SimScale simulation projects by gconley_nativi | Page 1

gconley_nativi's profile

Centrifugal pump with no changes to impeller blade angle

Centrifugal pump with minus 4 degrees change to the impeller

Centrifugal pump with plus 4 degree change to the impeller

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

gconley_nativi's profile