SimScale simulation projects by epsBam | Page 1

epsBam's profile

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry.

This project aims to showcase the process of setting up and running an incompressible analysis. As a geometry, we have a Francis turbine. A MRF Rotating Zone is used for the runner.

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used.

Drone propeller flow analysis simulation using MRF model and SimScale standard mesher.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

epsBam's profile