SimScale simulation projects by dmitry_seleznov | Page 1

dmitry_seleznov's profile

The effect of numerics on the simulation quality and convergence time.

The air flow around a horizontal axis wind turbine HAWT and the resulting forces on the rotor are simulated.

In this project vibration analysis of jet engine is performed.

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models used in this analysis are taken from GrabCAD users who were the winners of GrabCAD 'Airplane Bearing Bracket Challenge'. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD.

In this project a static analysis of a crankshaft-piston-rod assembly is demonstrated.

Underrun protection part with design improvement. Due to results of the simulation under the critical load (load case 1): maximal deflection of the underrun beam was 441 mm. This is not acceptable, considering the design criteria of maximum displacement 400 mm. Thus, there is a lack of stiffness of underrun beam. The simplest way to increase this stiffness is increase the depth of the beam up to 49 mm (It was just 45 mm before the improvement).

In this project a frequency analysis of crankshaft is demonstrated.

In this project a nonlinear dynamic analysis of a valve spring is demonstrated.

This project involves the simulation of stress analysis of an aircraft wing. There are total 6 comparison configurations with 3 different models and two different load definition.

This project simulates instantaneous turbulent wake of a cylinder body via LES method.

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This project demonstrates the usage of rotating zones

In this project, a Dynamic Analysis was done to determine the physical behavior of a carabiner subjected to displacement along its strong axis.

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: https://www.simscale.com/forum/t/step-by-step-tutorial-homework-of-session-1/52675

The project simulates 2 cases of aircraft wings to compare the aerodynamic effects.

In this project a frequency analysis of a disc brake is demonstrated.

Public Profile

dmitry_seleznov's profile