SimScale simulation projects by desairishi63 | Page 1

desairishi63's profile

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

FSAE-Workshop-S3- Yaw angle- Analysis-Simulation

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

For step by step tutorial see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-1/78878
2. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-2/79350

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-1/78755
2. Tutorial part 2: https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-2/79155

In this exercise, you will complete a laminar pipe flow analysis

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

Incompressible Fluid Flow analysis of two globe valves

Public Profile

desairishi63's profile