Compressible

Find projects using the compressible analysis type here. | Page 126

Completely new duct exhaust design compared to previous revisions. Exit path is flat except for last bit of exhaust, which is angled downwards.

More downward exhaust angle, more acute exit angle. v5 was still impinging on the nozzle.

Exhaust angle is just a bit high on the nozzle, adjusted to lower slightly. Added vertical fence in exhaust path (to improve flow routing and printability on the forward nozzle only - to check resultant flow.

Increased exhaust angle downwards as v4 was impinging on nozzle

I checked the air resistance of a rhombus shape from the front.

Fan duct for part cooling. Adjustment of exhaust exit angle slightly downwards over Rev F.

Adjusted exhaust entry to bottom of part. Exhaust angle deflected lower again over Rev F v3.

To model leakage of a rod packing seal, totally failed

Ap project which analyses and improves a basic industrial blower system, the system is designed to extract a space in a working environment.

Launch a water balloon or other projectile using co2 canisters

Simulation of Chemical Storage Ventilation

Part cooling fan duct for Anycubic i3 Mega S with E3Dv6 hot end - revision 3. Updated exit geometry to alter angle upward slightly on the rear exhaust and also a change to improve the directional output in the X-Y plane compared to Rev D v4.

Compressible | SimScale Project Library | Page 126