Compressible

Find projects using the compressible analysis type here. | Page 11

I'm a fan of 3D printing.
I really want to improve the design from the UT guy Under Dunn .
My version can be fully printed.

If the community likes it, then I will continue to develop this design further.

Oh, and I really want to run my creation in XFlow.
I am a simple person, I want a beautiful simulation.

2D venturi design to combine dust extraction and vacuum workholding

In this modification, I have added several additional sections. This is done in one piece. You can add it more than once if you want.

Flow through a pipe with internal supports

cfd of vairatre rate air blast jeeto sprayer

This modification concerns the second stage of the cyclone. 
The edge for dumping fine dust has become smoother. 
The number of turns of the secondary swirler has slightly decreased. This will allow the air to align somewhat before passing the ring-shaped gap.

simulation of part cooling with berd air system

Comparing cold flow in a solid fuel swirl burner between openfoam and fluent

CAD https://grabcad.com/library/sl_st-heat-recuperative-ventilation-1

The principle of operation.
Two oncoming streams pass through thin channels.
The only thing that separates the air flows is a thin aluminum foil. In this way, a constant temperature gradient is created and throughout the entire path, one stream cools, the other heats up. Theoretically, we will lose only a few degrees of our heat.

The structure consists of a layered structure of heat insulators (laser-cut plywood) and heat exchangers (aluminum foil, kitchen).

Cheap to manufacture and easy to operate design. On the model you can see the direction of the flows. This design will keep your home warm or keep cool.

At the same time, you will calmly renew the air in the room. As for me, nothing can compare with the thermal conductivity of such a thin heat exchanger. I will be glad to hear your comments.

Compressible | SimScale Project Library | Page 11