SimScale simulation projects by aspsenia | Page 1

aspsenia's profile

Using the software SimScale, you must design a nozzle, with a 10 cm length, outlet orifice 10 mm, inlet orifice 20 mm, outlet pressure 1 bar, and inlet velocity 10 m/s.
Doing this problem with two different fluids: water and air.

Design an intake manifold for the four cylinders with a maximum length of 1.5 m and a maximum pressure loss from the start to the entry of the last 250 Pa cylinder. Adjust the design according to the results with the SimScale.

Public Profile

aspsenia's profile