SimScale simulation projects by anna_m_flessner | Page 1

anna_m_flessner's profile

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This project incorporates the SimScale Add-in for Autodesk Fusion 360

Weight is one of the most critical parameters in aircraft design. In this challenge, you will be provided with a baseline design of an aluminum aircraft wing. Your objective is to reduce the weight of the wing without exceeding the maximum allowable deflection (+ y direction) of .90 meters.

Test two types of cardiovascular stent models (shown in the figure below) with two different metallic materials

Related to step-by-step tutorial of the biomedical workshop (session 2) https://www.simscale.com/forum/t/biomedical-engineering-workshop-session-2-analysis-of-cardiovascular-stent/36862

Tutorial project for setting up the Automated Hex-dominant for internal flow for an angled pipe geometry.

Public Profile

anna_m_flessner's profile