Explore agentic engineering workflow on SimScaleExperience Engineering AI
Static and Thermal analysis cutting tool
485
4
Statistics
1 Geometry
1 Mesh
2 Simulation setups
5 Results
1 Geometry 1 Mesh 2 Simulation setups 5 ResultsAbout this project
This simulation aims to simulate the static forces acting on a cutting tool insert and support under the following conditions. The final turning tool insert characteristics were: ap 1.8 mm (0.3-4.2) fn 0.19 mm/rev. (0.09-0.28) C 225 m/min. (310-150) The characteristics of the cutting tool shank: Tool cutting edge angle: 75 Tool lead angle: 15 The cutting condition of the task was: depth of cut (t) 2 mm feed 0.2 mm/rev. cutting speed 200 m/min cutting material, C45 (DIN) The forces acting on the cutting area are: Fx: -1436.5N Fy: 1447.8N Fz: -180.2N
