SimScale simulation projects by aldes | Page 1

aldes's profile

Duct placement study: Window closed, 150 CFM @ 17 deg C

Duct placement study: Window open, 150 CFM @ 17 deg C

Convective solver with compressible and radiation effects. DOE details: X1: CFM - 100, 150 X2: Outlet position - Baseline, Config1 X3: Duct position - Baseline, Config1 X4: Window1 - Closed, Open Runs: 16 (full factorial) Y1: Average PMV on a cut plane @4ft from the floor (sitting height) Y2: Average PPD on a cut plane @4ft from the floor (sitting height)

Convective solver with compressible and radiation effects.

DOE details:
X1: CFM - 100, 150
X2: Outlet position - Baseline, Config1
X3: Duct position - Baseline, Config1
X4: Window1 - Closed, Open
Runs: 16 (full factorial)
Y1: Average PMV on a cut plane @4ft from the floor (sitting height)
Y2: Average PPD on a cut plane @4ft from the floor (sitting height)

This is a setup to run a design of experiment (DoE) for the thermal comfort studies on a part of SimScale office. The objective is to optimize the thermal comfort in the office.

Had to cut the DOE in two halves as SimScale did not allow to change mesh for same CAD

Test run to understand the SimScale workflow

Demonstrate a simulation project for Thermal Comfort Analysis to a
new customer

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

aldes's profile