Set up your own cloud-native simulation in minutes.Start Simulating Now
Austria - Practical Exam (ME0041L)
0
0
Statistics
1 Geometry
1 Mesh
1 Simulation setup
1 Result
1 Geometry 1 Mesh 1 Simulation setup 1 ResultAbout this project
To submit the requirements for the Practical Exam of Machine Design 2 (Lab) with the following guidelines: - Import the project file into your Workbench by copying the file from this link. - The pulley is made of iron and the axle and arms are made of steel. - All degrees of freedom of the outer cylindrical face of the pulley is set to zero. - A 200-lb force is gradually applied to the top pin of the crank arm in the direction shown. The forces are 0 at 0 s, 100 lb at 0.5 s, and 200 lb at 1 s. - Add a volume results volume control min-max von Mises stress calculation for the top crank arm where the force is applied before running the simulation. - Run the simulation and answer the questions in this assessment.
