SimScale simulation projects by Tex03 | Page 1

Tex03's profile

Testing a hatchback with a slight dimple pattern at the rear of the car,

Testing the (almost) mythbusters golf car.

Testing a dimpled 6 mm (in diameter) BB pellet, to show difference in C_d.

Testing a ball with the radius of a golf ball without dimples for it's drag coefficient.

Testing a normal 6 mm BB pellet (airsoft) to see C_d.

Testing whether or not a golf car (in the shape of a sedan, in comparison to Mythbuster Ford Taurus) is more aeordynamic compared to a normal sedan.  OBSERVE: Just roof dimpled, and middle front part not because some problem with Freecad

Testing another version where there are two sets of dimples on the back och the bullet.

Testing a Sedan dimpled at the beginning of the back window.

Simulating a model of a sedan car that I made.

Testing a combination of the back and front dimpled sedan.

Testing a sedan dimpled at the end of the front window.

Testing a modified/dimpled version of 9x19 mm Parabellum.

Testing another model based on the 9x19 mm Parabellum.

Simulating a 9 mm bullet projectile (modeled after the 9x19 Parabellum), as a comparison to the next models.

Trying to do a simulation of a 9 mm bullet, with compressible flow.

This projects aims to showcase the function of a golf ball's dimples, compared to a same ball of smooth surface.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

Tex03's profile