SimScale simulation projects by Subhkaran_singh | Page 1

Subhkaran_singh's profile

This tutorial aims to showcase how to set up a compressible analysis. An aircraft wing geometry is used.

Dynamic Vibrational and Modal Analysis of Tether Drone Arm x1 - Copy

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C. A Conjugate Heat Transfer v2.0 analysis is used. - Copy

In this tutorial, the transport of exhaust gases into the atmosphere is simulated. Gases will come out of two chimneys of a plant. - Copy

In this tutorial, the transport of exhaust gases into the atmosphere is simulated. Gases will come out of two chimneys of a plant.

This tutorial project aims to showcase how to set up and run a simulation for a pump geometry. The Standard meshing tool was used. - Copy

This validation case belongs to fluid dynamics. The aim of this validation case is to validate the conjugate heat transfer(CHT) v2.0 analysis implemented in SimScale.
The simulation results of SimScale were compared to the results presented in the study titled  Unshrouded Plate Fin Heat Sinks for Electronics Cooling: Validation of a Comprehensive Thermal Model and Cost Optimization in Semi-Active Configuration written by L. Ventola, G. Curcuruto, et. al. - Copy

Public Profile

Subhkaran_singh's profile