SimScale simulation projects by Seetharamkoya | Page 1

Seetharamkoya's profile

This project validates distributed pressure and nodal stresses for a thick plate under pressure load.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

comparison of heat transfer in a beam using simulation and hand calculation

simulation of Cantilever Beam using point load

The main goal of the project is a simulation of incompressible flow through the pipe

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

In this exercise, you will complete a laminar pipe flow analysis

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

Incompressible Fluid Flow analysis of two globe valves

Public Profile

Seetharamkoya's profile