SimScale simulation projects by SairajuPonnoju | Page 1

SairajuPonnoju's profile

Convergence analysis for different situations: Notched plate, incompressibility, shear locking during bending

Project for Exercise 1 of Thermal Professional training exam. To register for the training, please follow this link: https://www.simscale.com/professional-training/

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

In this exercise, you will complete a laminar pipe flow analysis

Conjugate heat transfer analysis - heat sink

Thermal professional training - Session 2 - Task B

Incompressible Fluid Flow analysis of two globe valves

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

Weight is one of the most critical parameters in aircraft design. In this exercise, you will be provided with a baseline design of an aluminum aircraft wing. Your objective is to reduce the weight of the wing without exceeding the yield stress and maximum allowable deflection

Exercise for Session 5 of FEA Professional Training: Advanced Concepts in Structural Mechanics on SimScale. To register for professional training, please follow this link: https://www.simscale.com/professional-training/

Watches are not able to withstand 3 Bar Pressure Test. To check out ,Structural analysis of Case pipe is performed.

To perform CFD and Thermal Analysis of Hydroponic

CHT simulation of heat sink with temperature source

Static Linear and Nonlinear Analysis of a truck underrun protection

Static stress analysis of a loaded L-shaped angled bracket.

Project for Exercise 3 of FEA Professional training exam. To register for the training, please follow this link: https://www.simscale.com/professional-training/

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

Exercise for Session 4 of FEA Professional Training: Dynamic analysis with SimScale. 
To register for professional training, please follow this link: https://www.simscale.com/professional-training/

Public Profile

SairajuPonnoju's profile