SimScale simulation projects by RohitGupta_2138 | Page 1

RohitGupta_2138's profile

Flow simulation of the aerodynamics of a UAV, Analyze the performance of wing at different  angle of attack.

FEA Master Class Session 3 handout: In this project the drop test of an iPhone 6 has been performed with and without case.

In this exercise, you will complete a laminar pipe flow analysis

FSAE-Workshop-S3- Yaw angle- Analysis-Simulation

Simulating the aircraft wing with applied bending and torsional load due to wind pressure.

This project is the starting point for the homework for Session 1  of  the Baja SAE workshop. It enables the user to analyse the plastic deformation in an All Terrain  Vehicle (ATV)  Suspension .

This project has expanded a bit to include the following:
-Result validation of NACA0012
-Turbulence model comparison (LES and RANS) for NACA0012

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

For step by step tutorial see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-1/78878
2. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-2/79350

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

Drone Blade analysis at different speed and AOA

Incompressible Fluid Flow analysis of two globe valves

The effect of numerics on the simulation quality and convergence time.

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-1/78755
2. Tutorial part 2: https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-2/79155

Aim is to set up the deformation of the drone arm when applying the lift force on it

Drone blade analysis at different rotational speeds and AOA

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

This is used as a starting point for the SimScale Users and participants of the Session  2 of the All-Terrain Vehicle Design Workshop

Public Profile

RohitGupta_2138's profile