SimScale simulation projects by Ravikumar | Page 1

Ravikumar's profile

Validation Case for CHT 2.0 - 
This project has simulation that compares the results with test 4 from the orthogonality study in the paper

Validation Case for CHT 2.0 - 
This project has simulation that compares the results with test 1 from the orthogonality study in the paper

Validation Case for CHT 2.0 - This simulation studies the effect of natural convection on single cell

Validation Case for CHT 2.0 -
This project compares the temperature distribution for the complete battery module and a sliced one fourth symmetric part of the same battery module. Channel size 1mmx5mm, 5 Channels

Validation Case for CHT 2.0 - This project considers the initial geometry of the flow channel inside the cooling plate. The numbers of channels are 7 and the size of each channel is 1mmx5mm. This to compare the results with those from the paper. The simulation is run for 1000s

Validation Case for CHT 2.0 - This project considers the optimised design of the flow channel inside the cooling plate. The numbers of channels are 7 and the size of each channel is 1mmx5mm. This simulation is to compare the results with those from the paper. The simulation is run for 1000s

Validation Case for CHT 2.0 - 
This project has simulation that compares the results with test 7 from the orthogonality study in the paper

Validation Case of CHT 2.0 using local mesh controls

Body generates heat at a constant rate. Aim to study the effects of natural convection.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Study of Heat Transfer in an Engine Piston

Tutorial project for heat transfer in an engine piston

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

Ravikumar's profile