SimScale simulation projects by ROHIT_SR | Page 1

ROHIT_SR's profile

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

The project goal was to find the best airflow around the operation theatre with a different Duct model.
so to achieve this goal, the duct was simulated with incompressible flow simulation type and then operation room was simulated with convection heat transfer simulation type.
At the end, The results of both duct design were compared and find the optimum duct design with respect to the operation room.

Porous Media Test3, new set of parameters.

The project goal was to investigate the total downforce generated by the front wing of the 2019 car.
so for this simulation, I will use the incompressible type.
in 2019 F1 season was one of the best overtaking seasons so far. this happen just because of the NEW aerodynamic rule was help the drive to push the car at maximum limit.

The main aim of the project was trying to find stress and total displacement on the surface and check with experimental results. In this project, F1 halo is simulated in two different static load condition and for that use SIMULATION TYPE was STATIC. The halo is a driver crash protection system used in open wheel racing series which consists of a curved bar placed to protect the drivers head. The system was introduced in 2015 and became mandatory according to FIA homologation and regulation from 2018.

Here , you can see a straight pipe of L equal to 20 m and D equal to 1m

The aim is to obtain a correct yplus and pressure drop with a proper mesh. 

Postprocessing has been validated with the theoric results.

The goal of the project was to demonstrate the hydraulic jump and find the height of the jump also compare simulation height with the calculated height. For this project, I used a multiphase simulation type (air and water).

The aim of the project was to implement a porous media option and try to understand the basic concept behind through CFD setup. for this case, incompressible flow simulation type was used. In this case, the pressure drop across the two was calculated and done some iteration.

Incompressible Fluid Flow analysis of two globe valves

This is the simulation of the F1 2018 front wing flow simulation

Public Profile

ROHIT_SR's profile