SimScale simulation projects by Auday | Page 1

Auday's profile

A device used for shaft run-out correction

In this exercise, you will complete a laminar pipe flow analysis

FEA Master Class Session 3 handout: In this project the drop test of an iPhone 6 has been performed with and without case.

Trial 3, I made a boiler tube and trying to simulate the fluid flow and what is causing a repeated failure, it looks like there is a turbulence after the swage, interesting!, although i don't have exact parameters, i just used real estimates.

Incompressible Fluid Flow analysis of two globe valves

Design of simple A-Beam, and study the stress exerted and FOS

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

Auday's profile