SimScale simulation projects by 1318980 | Page 1

1318980's profile

An analysis of a Land Rover Defenders fuel tank on cornish roads :)

Aerodynamic design, Optimisation, structural analysis and transient design demonstration (thats the plan anyway)

This project has expanded a bit to include the following:
-Result validation of NACA0012
-icing of NACA0012
-Turbulence model comparison (LES and RANS) for NACA0012

1. Run and MRF Steady-State Simulation of tyre
2. Run AMI of Transient Simulation of Tyre
3. Run a MultiPhase analysis of Tyre in 2mm of water with a 1mm clearance

Testing Simscales time to solve a natural convection problem

This project simulates opening of a pressure relief valve using 6 DOF body motion.

A project to compare the pressure drag around a bluff body with different entry turbulent conditions.

Related to step-by-step tutorial of the biomedical workshop (session 1)

https://www.simscale.com/forum/t/biomedical-engineering-workshop-session-1-stress-shielding-in-a-hip-joint-prosthesis/36830/3

Studying the flow in and around a radiator.

Analysis on large scale 3D printer structure

An experiment to visually demonstrate the difference in lift generation between delta and straight wings, and why the delta wing has a more steady stall.

This project demonstrates the usage of rotating zones

Webinar Project- Carotid Artery Bifurcation
The project simulates the flow of blood as a non-newtonian fluid through a realistic Carotid Artery Bifurcation. Simulation are performed for 3 cases- of a healthy blood vessel  with no calcification or blockage and through an moderately and severely calcified or blocked blood vessel. 
The results show the differences in pressure, velocity profile and the outlet flow  through the 2 branches.

Flow conditions are based on a paper: STUDY OF BLOOD FLOW IN A BIFURCATION WITH A STENOSIS,
Sonia I.S. Pinto, E.D. Costa, J.B.L.M. Campos, J.M. Miranda

A project to observe heat transfer between a heated and a cooling plate and a body of water. Emphasising on observing the transition from conductive to convective dominant heat transfer and mixing.

Tags: Rayleigh-Bénard, Convection, Conduction,  LES, Transient, Heat transfer, plumes, vortecies.

This is a project to further my understanding of wind turbine geometry, and to share it with the community

Related to step-by-step tutorial of the biomedical workshop (session 2) https://www.simscale.com/forum/t/biomedical-engineering-workshop-session-2-analysis-of-cardiovascular-stent/36862

My first Natural convection Simulation... Any thoughts on improvements please comment :) 

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime.

This project involves the simulation of stress analysis of an aircraft wing. There are total 6 comparison configurations with 3 different models and two different load definition.

This project involves the simulation of ventilation in an aircraft cabin. There are 6 comparison configurations with 3 different inlets and 2 outlets.

CFD analysis of internal flow

edited altering iterations and adding result control for convergence monitoring.

To validate setup with various turbulence models, against experimental data.

Collecting data on wing for optimise in TS Inspire

To validate that MRF produces correct results

The project simulates 2 cases of aircraft wings to compare the aerodynamic effects.

This project simulates incompressible flow through an industrial scale Butterfly Valve.

First 2018 full SimScale simulation.

Main targets are the following:
-Determine suitable mesh parameters -in general-
-Determine suitable simulation parameters -in general-
-Set to work rotating BC for the wheels

Public Profile

1318980's profile