SimScale simulation projects by zefeng | Page 1

zefeng's profile

Will adding stiffeners change the modes - Copy

Push gently with a hard drive actuator - Copy

First iteration of a Electronic Ducted Fan to be 3-D printed.
Notes-
Not optimized for printing.
45 degree Angle Of Attack
Turbofan Compressor cross-section
7 in. Diameter - Copy

to check the velocity and temperature of a inlet presure - Copy

This tutorial aims to showcase how to set up a compressible analysis. An aircraft wing geometry is used. - Copy

The project simulates 2 cases of aircraft wings to compare the aerodynamic effects. - Copy

An experiment to visually demonstrate the difference in lift generation between delta and straight wings, and why the delta wing has a more steady stall. - Copy

In this project a structural and an eigenfrequency analysis of a front wing is demonstrated. - Copy

Weight is one of the most critical parameters in aircraft design. In this exercise, you will be provided with a baseline design of an aluminum aircraft wing. Your objective is to reduce the weight of the wing without exceeding the yield stress and maximum allowable deflection - Copy

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime. - Copy

Tutorial project for Aerodynamic simulation of compressible flow over Airfoil - Copy

This project demonstrates the static stress analysis of three aircraft engine bearing bracket models considering both linear and nonlinear material definition. The models are tested with horizontal and vertical loading conditions as provided on the challenge page of GrabCAD. - Copy

This tutorial showcases how to use SimScale to run an electromagnetics simulation on a Magnetic Lifting Machine.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

External aerodynamics on a vehicle - Copy

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation. - Copy

Tutorial project for linear static analysis of a crane

Public Profile

zefeng's profile