Looking for displacement simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 1

Static analysis of pure bending (moments only). Compare with theoretical results.

This simulation project aims to show the buckling of the column whose one end is fixed and force applied on the other end.

Stress analysis design of an assembly using snap fits

The main aim of the project was trying to find stress and total displacement on the surface and check with experimental results. In this project, F1 halo is simulated in two different static load condition and for that use SIMULATION TYPE was STATIC. The halo is a driver crash protection system used in open wheel racing series which consists of a curved bar placed to protect the drivers head. The system was introduced in 2015 and became mandatory according to FIA homologation and regulation from 2018.

In this project, static FEA of a cantilever beam subjected to the concentrated load at the free end has been performed. The deflection in y direction of the free end of the beam has been calculated via static analysis and hand calculation which came to be very close to each other as the mesh is made finer.

The aim is to dimension the mast of a light pole of 11 meters high with variable diameters. The implementation of the project will be in the patio of Raízen in Marabá-BR, located on the railroad.

The effect of the truss thickness on the maximum stress in the arm.

Frame will be used to hold the front two battery boxes and the DMOC.  See lopified.blogspot.com for car details.

This is a comparison between the results of Simscale and the hand calculus for a simple beam

Stress analysis of leaf-spring under different loads (40N, 100N, 1kN)

In this project two holder assembly models harmonic analysis was performed. Both models were taken from lr2015mp.