Looking for 3d printing simulation templates? Sign up for SimScale and join the largest engineering simulation community in the world! | Page 5

Adjusting exhaust angle slightly upward - too low on v6

Adjusted internal fencing, adjusted nozzle exit angle upwards

More downward exhaust angle, more acute exit angle. v5 was still impinging on the nozzle.

Completely new duct exhaust design compared to previous revisions. Exit path is flat except for last bit of exhaust, which is angled downwards.

Exhaust angle is just a bit high on the nozzle, adjusted to lower slightly. Added vertical fence in exhaust path (to improve flow routing and printability on the forward nozzle only - to check resultant flow.

Adjusted exhaust entry to bottom of part. Exhaust angle deflected lower again over Rev F v3.

Fan duct for part cooling. Adjustment of exhaust exit angle slightly downwards over Rev F.

Increased exhaust angle downwards as v4 was impinging on nozzle

Simulating airflow for a chimera+ cooling duct.

Part cooling fan duct for Anycubic i3 Mega S with E3Dv6 hot end - revision 3. Updated exit geometry to alter angle upward slightly on the rear exhaust and also a change to improve the directional output in the X-Y plane compared to Rev D v4.

Part cooling fan duct for Anycubic i3 Mega S with E3Dv6 hot end - revision 3. Updated exit geometry to alter angle downward slightly on the rear exhaust compared to Rev D.

Part cooling fan duct for Anycubic i3 Mega S with E3Dv6 hot end - revision 3. Updated  exhaust exit geometry to alter angle downward slightly compared to Rev C and Rev C v4.

Maker Select V2 fan duct - Ceberus - 3 headed monster

Bending stress and bending moments on patient-specific laryngoscope blade

Test flow of air in  3d printer part cooler

An Open-Source 3D printer Framework Design for enthusiasts.

This project contains everything you need to work on your homework assignement

This project is used to identify the flow of air to the printing object (Ender 3 Stock fan)

3D Printer part cooling fan for tool changer design

In-Out A@Hr  separation unit.

Density changable Dual Sphere mechanichal validation of No Presure Volume Area.

Abilitizing healthe-ability to living ambient.

1. Try to simulate airflow in a 3D Printer Fan Duct

Silicone sock/part cooling duct for a delta 3D printer

fan shroud for part cooling in a E3D v6 based extruder

working on a new cooling fan for a TypeA Machines Series 1

Trying to evaluate my improved cooling duct

Part cooling fan duct optimized with nozzle

Simulate the operational airflow of proposed Elagoo mars resin printer extractors.

Optimization Printer Cooling of an Ultimaker Original with 1 and 2 nozzles

This is a projection or the rupture points, for ultimate tensile strength of different printed plastics that I'm working on.

3d printing | SimScale Project Library | Page 5