SimScale simulation projects by schneiderbcs | Page 1

schneiderbcs's profile

Starting the airflow movement thru 10 ft mold with free air around it

Modified venting for 4 foot and 3rd stack in South east corner of building

Moved the venting around the 4 foot mandrel

Facility with round venting in the 4 foot mandrel area

Recessed the vent near the ground level of the 4 foot mandrel

last model of 4 ft mandrel with correct venting and velocities

5 ft mandrel next to the filament winding system

second model for filament winding section

Final version of filament winding section

This has all the components internally and the venting velocities calculated in Plant Air Flow Cals rev05191

split mandrels with accurate venting locations and sizes

this tube has an obstruction inside the pipe to disturb the air flow

Have calculated the velocity correctly and size and placement of the venting

has some of the shells and vents but not correctly sized or correct values

External venting of 4 ft mandrel area 0505

Should be the last design needed for this area

This may be the final model for the unit 
this has 2 recessed vents and a floating mandrel with all dimensions reflecting the actual install

A little more accurate drawing of the 4 foot mandrel and with a recessed vent the shell is green colored

added the output vent from the last model and 4ft mandrel

single body with lid for the 4 ft mandrel

The vents are resessed and the no holes in the floor area

This building has all the inputs and outputs

The vent tube is in deeper into the shell

Public Profile