SimScale simulation projects by mohammadzaini | Page 1

mohammadzaini's profile

The tutorial project is a sample Electronic cooling sink which consists of 3 solid regions and 1 fluid region. The solid regions are two FB-4 chips, which have a higher initial temperature and a heat sink over one of the chips. The air flows over the solid regions to remove the heat from it.

Tutorial project to set up the Hex-dominant Parametric mesh for rotating geometries. This mesh can then be used for MRF and AMI simulations that incorporate rotation effects.

Tutorial for meshing of valve geometry with Snappy Hex Mesh

Sample project for how to set-up the Hex-Dominant Parametric mesh for flow around a vehicle body.

Tutorial - External Aerodynamics - Standard Mesher

Tutorial project for setting up the Automated Hex-dominant for internal flow for an angled pipe geometry.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

mohammadzaini's profile