SimScale simulation projects by jprobst | Page 1

jprobst's profile

Tutorial project for linear static analysis of a crane

This project involves the simulation of ventilation in an aircraft cabin. There are 6 comparison configurations with 3 different inlets and 2 outlets.

The aim of this project is to investigate the heat transfer through the assembly to get insights about the temperature distribution within the extruder

Example project of a room to later perform thermal comfort result visualization

The goal of this project is to determine the heat transfer rate and temperature on solid-state chips which emit heat. The simulation is of conjugate heat transfer type which considers the temperature changes between solid and fluid parts and also flow of fluids.

This project demonstrate the definition of passive scalar flux

Trying to see if the module is going to receive sufficient cooling.

Heating a block of material in a room with forced convection

Conjugate heat transfer analysis - heat sink

CHT simulation of heat sink with temperature source

This project aims to obtain the airflow inside two design alternatives for an HVAC system of a theater room. Convective heat transfer simulation is used to obtain the flow pattern inside the room. Thermal comfort parameters such as PMV (Predicted Mean Vote) and PPD (Predicted Percentage of Dissatisfied) are obtained along with the mean age of fluid.

Target: To find the maximum flow with minimum levels of vibration for the cross flow fan. This is a sample project to show the air flow for particular vibration experienced by the fan. Design changes needs to be made to narrow down to the best design

Simulations comparing 2 variants of fans and the corresponding flow. The geometry was provided by Friendship Systems - CAESES.

In this project a multiphase flow simulation of a stirred reactor is demonstrated.

Discovering the flow characteristics around a Gorlovturbine

Conjugate heat transfer validation. Air flow over a plate is considered for this case. The setup of CFD model and comparative results are explained in SimScale forum comments section of this project.

The project simulates 2 cases of aircraft wings to compare the aerodynamic effects.

In this project, airflow in a data center is evaluated by using convective heat transfer simulation based on the research article Data center - by Gao et al.

Public Profile

jprobst's profile