SimScale simulation projects by ewnugent | Page 1

ewnugent's profile

Keyboard plate consistency (WE KNOW v6 IS GOOD)

Keyboard Plate Consistency (Hotdog v2 plate)

Get plate to feel as consistent as possible

Tweaked spacing and also the top center mount

Bottom-left mounting point shifted 2.5mm left and widened by 1mm

Testing consistency of keyboard plate with mounting points on the top and bottom middle, and under the down arrow

Slightly shortened the far-right flex cuts

Slightly narrowed inner right-hand flex cuts

Tweaked left-hand flex cuts, attempting to strike a balance between Sandbox v3 and v4

Experimenting with further tweaks on the final draft

Extended bottom middle flex cut and tweaked asymmetry of top middle flex cut

FEA of another minor variant (adjusting middle flex cuts to try to even out the alphas)

FEA of minor variation of v5 mount (v5.1 makes the top center flex cut a bit smaller---1.5mm shorter on each end)

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

ewnugent's profile