SimScale simulation projects by dthakore | Page 1

dthakore's profile

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Same as StaticMixer2 but each part is rotated by 45degrees on its axis to give more mixing.

Same as StaticMixer4 but all holes lined up straight.

Same as Static Mixer 2 but with holes parallel to axis of part and at 45 degrees rotated

Increased hole diameter from 8 to 12mm and reduced angle of inclination from 35 degrees to 30 degrees

Blower surface at 90degC
Blower sucking flow from windows
Solar Heating at 500W/m2
No Whirlybirds
No Fan

Copied from Mirani4-1 with only difference that only 1 Fan on the left side is operating.

Copied from Mirani1-1 to check if the results of Mirani2-1 are correct or not.
Boundary Conditions are that of Mirani2-1.
Yes to WhirlyBirds
No to Fan

Walls at 40degC
Roof with 150 W/m2 solar radiation
Blowers at 90degC
Two side inlet ducts
Natural convection with no whirly bins working

Blower surface at 90degC
Blower sucking flow from windows
Solar Heating at 500W/m2
Whirlybirds sucking at 0.025m3/s
No Fan

Inlet Temp 40degC, Blower surface heating to 90degC

BlowerRoom where Outlet massflow is defined with pipe and blower temperature defined, need to find what should be the inlet fan speed and volume.

Public Profile

dthakore's profile