SimScale simulation projects by djshort | Page 1

djshort's profile

Rotor and shaft connection analysis. 4 step simulation:
1. Interference fit
2. Centrifugal load
3. Torque
4. Temperature increase

Engineering study of solar panels, including:

1. Wind loading and static structural analysis of a single panel

2. Transient wind analysis of a panel array

This project shows the sliding of a rubber seal on a rigid body due to applied displacement.

LED Spotlight project, aiming a bring the temperature of the diodes of a LED spotlight design below the maximum allowed temperature of 100C.

Structural simulation according to UN 38.3 T3 vibration test criteria

Example of how  Pedestrian Wind Comfort CFD analysis can be used within an architects design process.

Design study of a passively cooled LED module to inform heat sink material selection

This project analyses the dynamic impact stresses and deformation exerted on a pair of headphones that have been dropped from head height. A geometry change has been made after reviewing the max stresses in order to mitigate the risk of breakage.

Utilisation of CFD in the design cycle for a ventilation Louvre and duct system

Validating CO level during normal operations

Investigation of occupant thermal comfort for a naturally ventilated warehouse.

Air flow and contamination spread for multiple cleanroom designs

Internal flow and thermal analysis to understand the thermal comfort within a large atrium.  This is a typical example of the type of applications that our AEC customers perform on a regular basis.

Internal CFD study of air flow and thermal comfort.

This case validates the thermal management inside an LED against the CFD and experimental results obtained in the conference paper, Thermal Analyses and Measurements of Low-Cost COP Package for High-Power LED, using the Conjugate Heat Transfer v2.0 analysis type in SimScale.

Conjugate heat transfer simulation to analyse the thermal performance of water cooled transistors.

In this SimScale project, inspired by this article on cooling effectiveness, a CFD thermal analysis is used to predict the temperature of 30 commercial Li-ion 18650 cells under multiple casing designs and inlet flow conditions. The goal is to find the minimum cooling power so that the cells are kept below 40C.

Natural Ventilation of a department store.

The project shows how to use FEA to accurately predict the performance of a thermal shipper pack.

Flow through different vent diffuser designs and analysis of occupant thermal comfort.

Internal CFD to analyse air flow and thermal comfort

Analyse the duct positioning to have effective ventilation system

This analysis shows a use case for the frequency analysis on the SimScale platform.

Learn how to perform structural analysis utilizing non-linear material properties

This project uses a steady-state CFD analysis to investigate the aerodynamic performance and energy conversion capability of a vertical axis wind turbine. Both a stationary and rotating case is considered.

The presented project is an analysis of the thermal performance of a heat sink connected to chip. The chip acts as a power source generating 30W of heat. Using a conjugate heat transfer analysis allows for simulation of heat transfer between the solids via conduction and the dissipation of heat into the ambient fluid via convection. The components are cooled passively and buoyancy effects  drive the flow in the surrounding air.

The objective of this project is to evaluate the max temperature of the chip during operation and therefore a steady state analysis was carried out.

Tutorial for Static stress analysis of Underrun protection device

A small part of the SimScale office . We actually don't have any active cooling here (Germany) so we took a few liberties to make this more interesting!

Static-Linear structural analysis of a loaded mechanical arm with multiple contacts.

This project provides a setup template for analyzing the thermal comfort within a ventilated office space. The effects of radiation on the temperature distribution are included.

Public Profile

djshort's profile