Incompressible (LBM)

Find projects using the incompressible pacefish analysis type here. | Page 19

Aerodynamic Analysis of an F1 Front Wing - Copy

The CAARC building is a validation case that has for many years been used to validate CFD codes. This case has been shown in the past validating both URANS and LES turbulence models, where the trend has been that RANS/URANS has predicted the windward facade well but not predicted the sides and Leeward facades. In contrast, LES has shown a good agreement with experimental results, however, there is still in general, an over-prediction for the sides and leeward facade, and a worse prediction on the windward facade. In this project we look at SimScales LBM implementation, PaceFish from Numeric Systems, and how well it performs using Hybrid models, K-omega SST DDES, and k-omega SST IDDES models. These models use wall models based upon K-omega SST but then transition to the highly accurate LES model further from the wall. - Copy

The purpose of this project is to use experimental results from the Architectural Institute of Japan to validate CFD results gained from SimScale. The case being validated is Case E, which consists a complex of buildings with simplified geometry. Many scenarios are presented in Case E, The scenarios used to validate the SimScale platform were the North, East, South and Westerly winds for the after construction scenario.

The SimScale CFD results were compared to the experimental results and found to have good correlation. Some underprediction was seen in the k-epsilon models in the strong wind regions and underprediction in the wake regions, but is a known trait of the K-epsilon model and is acceptable and should be considered when evaluating results. - Copy

Automotive Aerodynamics - Formula 1 Car CFD Analysis

Please see the following on a detailed setup description: https://www.simscale.com/projects/cobrien/car_aerodynamics_-_le_mans_p1_1/ - Copy

Starting to understand this platform  from  a public project

Here I try to compute the Cd value for a 3D Object

The DrivAer car geometry model, simulated with SimScale using the Pacefish LBM Solver - Copy

Model frequency vs vortex shedding frequency around a building - Copy

Copy of Drivetrains Aver Project to explore

Versuch Revit Datei Workflow in Omniverse - Copy

Automotive Aerodynamics - Formula 1 Car CFD Analysis

Please see the following on a detailed setup description: https://www.simscale.com/projects/cobrien/car_aerodynamics_-_le_mans_p1_1/ - Copy - Copy

Incompressible (LBM) | SimScale Project Library | Page 19