Autodesk Inventor

Find all public projects containing Autodesk Inventor CAD models here. | Page 194

proyecto de curso, transferencia de calor

Jet atomization validation study - learning process

Analise estrutural de um componente automotivo

Denne modellen tar for seg hvordan modellen vil endre på seg da de ulike funksjonene vil endre på seg.

Testing hos LES will work on this geometry

con caudal de 200 litros por minuto y cabezal de 10 metros

The project simulates the flow of water through an orifice. The water is assumed to be incompressible and the k-omega SST turbulence model is used as the large pipe diameter and inlet velocity of 2 m/s is likely to result in a turbulent flow  and so using a laminar flow model would lead to incorrect results. It is possible to calculate the degree of turbulence via the Reynolds number. The results show that a jet forms after the orifice,  and the water attains a maximum velocity of 5.9 m/s. The orifice causes a low pressure region to form directly after the orifice. The pressure in the low pressure region falls to below the pressure and the outlet of the pipe. The jet leaving the orifice drives a toroid shaped vortex around the edges of the pipe. In the vortex region, the flow recirculates with minimal exchange of liquid. The orifice causes a large pressure drop, much larger than would occur if the entire length of pipe were of the diameters of the orifice.

Circular jet atomization study at singular Weber number

thermal simulation of a cube with cooling on three faces

Autodesk Inventor | SimScale Project Library | Page 194