Autodesk Inventor

Find all public projects containing Autodesk Inventor CAD models here. | Page 101

Using Model 2 in Heat Transfer simulation, assigning h-values, and including insulation

Use the bounding box in SimScale's CAD software instead of adding air in the Inventor assembly

Aerodynamic Simulation of a Rear Wing Model based on F1 Rear wings from the 2019 season

Simulación proyecto modelos matemáticos

Checking if radiator sim will run
8sqft radiator slats surface area

Using the value of h I calculated by hand on 17-1-22 for the convection from the upper hot surface of the Head of the T-shaped hot metering block. I am aware this value does not represent the convection from all surfaces, however it is a first attempt and a rough approximation.