SimScale simulation projects by asunder | Page 1

asunder's profile

Cooling of a PCB board with forced convection

This project is aimed at creating a parametric analysis of heat distribution within a 3D printer.

This project involves the simulation of ventilation in an aircraft cabin. There are 6 comparison configurations with 3 different inlets and 2 outlets.

Tutorial project for a thermal analysis of a differential casing. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

This project simulates air flow in an aircraft cabin. Two configurations and their effect on the air flow pattern are shown.

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime.

This project involves the simulation of stress analysis of an aircraft wing. There are total 6 comparison configurations with 3 different models and two different load definition.

to check the temperature distribution within the extruder

The analysis of drone for different designs

Thermal simulation of fluid flow in heat sink

Steady state and transient thermal analysis of a pcb

Simulate the simulation  IC on a PCB. Simulate the steady state and investigate the transient state

Public Profile

asunder's profile