SimScale simulation projects by ahancock | Page 1

ahancock's profile

More aggressive attack with a hole for engine cooling

undertray 13 - 3 pathways underneath with a larger element design than 12

just the nose cone and body with just diffuser elements, no undertray

the big one just without the undertray, for reference

this is the second run on the undertray v10, with lower clearance

same as 9, but with the elements moved back a little bit

Undertray v8, added a second element and have taken out the middle part of the diffuser

same as 8 but with a high angle of attack for element 2

The same as 6, however more walls are integrated

This undertray includes an element that stretches the entire width of undertray v5, but with a whole for air flow into the engine.

The new and improved version of undertray 4, with the addition of a 4 inch diffuser

Undertray 4, changed from flat bottom to an actual aerodynamic flow

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

ahancock's profile