SimScale simulation projects by Torque | Page 1

Torque's profile

Homework for FSAE workshop. Front Wing Redesigned

Various settings for airfoil simulation study

In this exercise, you will use linear static analysis to analyze several configurations of an aircraft engine bracket under a vertical load.

The effect of numerics on the simulation quality and convergence time.

Tutorial project for a flow analysis of a pipe junction. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

In this exercise, you will perform a simple heat transfer analysis on the SimScale Platform and then compare the results to a hand-calculated solution.

In this exercise, we will consider the deflection of a cantilever beam with a concentrated load at the free end. We can calculate the deflection by hand and via a static analysis using the SimScale platform.

In this exercise, you will complete a laminar pipe flow analysis

Incompressible Fluid Flow analysis of two globe valves

FSAE-Workshop-S3- Yaw angle- Analysis-Simulation

FSAE-Workshop Session-2 Homework project for aerodynamics of complete Formula Student Race Car

For step by step tutorial see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-1/78878
2. https://www.simscale.com/forum/t/step-by-step-tutorial-session-2-full-car-aerodynamics-part-2/79350

FSAE workshop session 1-Front Wing Analysis homework tutorial project.
For Step-By-Step see: 
1. https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-1/78755
2. Tutorial part 2: https://www.simscale.com/forum/t/step-by-step-tutorial-session-1-front-wing-design-study-part-2/79155

Tutorial project for a stress analysis of a connecting rod. The project only provides the geometry to start with. See our tutorials section to have a look at the step-by-step instructions to set up the simulation.

Public Profile

Torque's profile