How Leaders are Escaping AI Pilot PurgatoryRegister here
Centrifugal Blood Pump Simulation
0
0
Statistics
0 Geometries
0 Meshes
0 Simulation setups
0 Results
0 Geometries 0 Meshes 0 Simulation setups 0 ResultsAbout this project
Simulate flow of blood like material in a centrifugal pump with boundary conditions The volume flow rate in the outlet was chosen equal to 5 l/min Pressure in the inlet was chosen to be 40 mmHg The rotating velocity of the impeller was considered to be 2500 rpm. the problem must be broken up into multiple zones (stationary zone and rotational zone), with well-defined interfaces between the zones59 Outer walls were stationary, but the inner walls were rotational, while no-slip boundary condition was applied on them.
