SimScale simulation projects by SamPrabhu | Page 1

SamPrabhu's profile

This project includes the shell and tube heat exchanger simulation using the conjugate heat transfer technique, abbreviated as CHT. Conjugate heat transfer defines processes which involve variations of temperature in solids and fluids due to thermal interactions.

This project aims to obtain the airflow inside two design alternatives for an HVAC system of a theater room. Convective heat transfer simulation is used to obtain the flow pattern inside the room. Thermal comfort parameters such as PMV (Predicted Mean Vote) and PPD (Predicted Percentage of Dissatisfied) are obtained along with the mean age of fluid.

In this project, airflow in a data center is evaluated by using convective heat transfer simulation based on the research article Data center - by Gao et al.

Simulations comparing 2 variants of fans and the corresponding flow. The geometry was provided by Friendship Systems - CAESES.

This project shows an electronic cooling application of ICs on PCB using the conjugate heat transfer transfer technique, abbreviated as CHT. Conjugate heat transfer defines processes which involve variations of temperature within solids and fluids due to thermal interaction.
You can find the tutorial for this project here: https://www.simscale.com/docs/tutorials/conjugate-heat-transfer-cooling-of-electronic-sink/

CHT simulation of heat sink with temperature source

The project simulates 2 cases of aircraft wings to compare the aerodynamic effects.

This project shows how to simulate the airflow inside an office space.

This project involves the simulation of ventilation in an aircraft cabin. There are 6 comparison configurations with 3 different inlets and 2 outlets.

Conjugate heat transfer validation. Air flow over a plate is considered for this case. The setup of CFD model and comparative results are explained in SimScale forum comments section of this project.

The air flow around a football is simulated with focus on the effects of the pattern on the football surface and spinning of the ball.

In this project a multiphase flow simulation of a stirred reactor is demonstrated.

This project demonstrate the definition of passive scalar flux

Discovering the flow characteristics around a Gorlovturbine

Conjugate heat transfer analysis - heat sink

Example project of a room to later perform thermal comfort result visualization

Trying to see if the module is going to receive sufficient cooling.

Target: To find the maximum flow with minimum levels of vibration for the cross flow fan. This is a sample project to show the air flow for particular vibration experienced by the fan. Design changes needs to be made to narrow down to the best design

The aim of this project is to investigate the heat transfer through the assembly to get insights about the temperature distribution within the extruder

Predict the resistance and trim angle of a planing hull.

This project simulates the natural convection in a kitchen

This project involves the simulation of ventilation in an aircraft cabin.

the flow gas of two boiler flow throw in on medium

The goal of this project is to determine the heat transfer rate and temperature on solid-state chips which emit heat. The simulation is of conjugate heat transfer type which considers the temperature changes between solid and fluid parts and also flow of fluids.

This project simulates air flow around an Aircraft at low sub-sonic compressible flow regime.

Aerodynamic analysis of small gravity powered vehicle.

Public Profile

SamPrabhu's profile