Unexpected Mesh Error

Project Support
1

Hi,

I’ve been trying to mesh a propeller to analyze its performance. I want to use a MRF to simulate the rotation of the propeller. For some reason the mesh keeps failing, but the error I get does not provide a lot of information. It only says: “An unexpected error happened during mesh generation”. When I check the mesh log, it looks as if the mesh was successfully generated.

Any advice?

This is the link to the project:

Thanks!

2

Hi,

Could you try replacing the word “Rotor” for “Zone” here, in the cell zone definition?

image
image817×707 31.3 KB

This should allow the mesh to finish.

Cheers

1 Like
3

Hi Ricardo!

It worked! Thanks. It was actually just a simple mistake.

Thanks again.