I created a new simulation project called 'test of the new capabilities':
Just to try the new capabilities
More of my public projects can be found here.
Hi @mcf_1, I noticed one simulation run ended up with an error. Anything we can help? Cheers!
Yes please, I need some help.
I would like just to pull with 50 tons from the lower hole
holdign the part in the upper hole.
It looks a fairly simple simulation but I am unable to set it properly
Hey Miguel (@mcf_1)!
I have seen your simulation. There are some improvements which can help you running a successful analysis:
If you have same material assigned to all solids of your assembly, than try to merge all solids to have one prior to making mesh. Re-upload the geometry once merged, mesh it and do the same setup and it will work.
In case you don’t want to merge all solids, you have to define bonded contacts between them which will be an overwork if you wish to do so. Please have a look at this forum post.
If you are applying load through remote force boundary condition, please be aware that this boundary condition is only applicable for small loads and may give wrong results if large load/s is applied.
Hope this helps you. If you have any further question/s, feel free to ask. Happy Simulating!
@mcf_1, I’ve fused the geometry into one solid as @ahmedhussain18 explained above and ran the simulation (Simulation 2). You can have a look here:
Thank you very much for your help!
I will try myself anyway merging all solids to see if I am able to do run the simulation