# Simulation Problem

**URL:** <https://www.simscale.com/forum/t/simulation-problem/82614>\
**Category:** Project Support\
**Created:** [June 8, 2018, 7:28am UTC](https://www.simscale.com/forum/t/simulation-problem/82614 "2018-06-08T07:28:23Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![jousefm](https://www.simscale.com/forum/user_avatar/www.simscale.com/jousefm/32/34908_2.png) [@jousefm](https://www.simscale.com/forum/u/jousefm)\
**Post date:** [June 8, 2018, 9:04am UTC](https://www.simscale.com/forum/t/simulation-problem/82614/2 "2018-06-08T09:04:27Z")

</div>

Hi @pkvoon!

Regarding the mesh I would also make sure to use inflated layers to capture gradient information. Could you explain why exactly you use the conditions you are using at the moment? Do you have reference values?

Just as an information: Prescribing the **total pressure** at the inlet allows you to get a **fully developed** profile in all pipe extension, which should (theoretically) match the pressure losses better than a velocity inlet.

As mentioned above and to avoid problems you need to satisfy y+ (**[Y-Plus](https://www.simscale.com/forum/t/what-is-y-yplus/82394)**) parameters in the near-wall region to use k-epsilon model appropriately.

* * *

Best,

Jousef

---

_[View the full topic](https://www.simscale.com/forum/t/simulation-problem/82614)._
