Simulation failed, No indication of what when wrong

Using SimScale Fluid Flow / CFD
1

New to SimScale (really awesome site btw). I’ve done some work with OpenFOAM before but it’s been a little while. Anyway, all of my runs stop after 100-300 iterations, saying run failed, but give no clue as to what happened; no errors in the log. My mesh has a high skewness so I’m thinking that could be the issue? Any suggestions would be appreciated, thanks.

Link to Project: https://www.simscale.com/workbench/?pid=1661455023305268615#tab_1-0

1 Like
2

Hi @mtaylor! Welcome on board and thank you for your kind words - much appreciated! :slight_smile:

I did a simulation with your model.

Check it out: GT86 V2

Best,

Jousef

1 Like