Nice to see the mesh! It looks good. One can also refine it more by selecting either 3 - Moderate or 4 - Fine. Nevertheless, let’s give a try to first analysis . You can do the following:
Change analysis type to Static analysis - advanced under Analysis type. This analysis type has more boundary condition options like force, remote force, remote displacement etc.
For bending the pipe, you can apply the following boundary conditions as shown in the figure below i.e. constrain the far face in all directions (x=y=z=0) and apply a force of lets say 5 N in negative y-direction on near face.
Selecting and assigning a face to boundary condition is simple. Just select the face on your geometry from the viewer by clicking left mouse button and than click Add selection from viewer. Make sure that your selection is on Pick faces mode as shown on the viewer top as .
Hope this will help to setup your first case with this model. If you have any question/s, feel free to ask. Happy Simulating!