PCB Heat transfer Simulation failure

Project Support
1

Hi,
I am trying to simulate the heat transfer of electronic components through PCB (Tet-Dominant mesh, Heat Transfer Simulation).
It would be great if I can get a hint why the simulation fails since there is not much of information in the server log.

Many thanks in advance,
Nagaraj

2

Hi Nagaraj (@anagaraj), your simulation has failed because it ran out of memory. The more computing cores you use the more memory available to you. Please see this link for details.

Please try increasing the number of computing cores (under Simulation Control) and try again.

2 Likes
3

Thanks a lot for the guidance.
It worked!

1 Like