# Modeling boundary layer fan (aka inverted Tesla turbine)

**URL:** <https://www.simscale.com/forum/t/modeling-boundary-layer-fan-aka-inverted-tesla-turbine/90991>\
**Category:** Project Support\
**Created:** [December 16, 2020, 4:28pm UTC](https://www.simscale.com/forum/t/modeling-boundary-layer-fan-aka-inverted-tesla-turbine/90991 "2020-12-16T16:28:34Z")\
**Posts on this page:** 1\
**Showing post:** 19

<div class="post-metadata">

**Author:** ![kubark42](https://www.simscale.com/forum/user_avatar/www.simscale.com/kubark42/32/28291_2.png) [@kubark42](https://www.simscale.com/forum/u/kubark42)\
**Post date:** [December 17, 2020, 6:49pm UTC](https://www.simscale.com/forum/t/modeling-boundary-layer-fan-aka-inverted-tesla-turbine/90991/19 "2020-12-17T18:49:21Z")

</div>

Ah, looks like the required mesh behavior isn’t something Simscale supports right now: [Wedge BC meshing issue - Help Please - #5 by jousefm](https://www.simscale.com/forum/t/wedge-bc-meshing-issue-help-please/88709/5)

---

_[View the full topic](https://www.simscale.com/forum/t/modeling-boundary-layer-fan-aka-inverted-tesla-turbine/90991)._
