# Mesh study external aerodynamics problem

**URL:** <https://www.simscale.com/forum/t/mesh-study-external-aerodynamics-problem/85030>\
**Category:** Project Support\
**Created:** [April 11, 2019, 2:02am UTC](https://www.simscale.com/forum/t/mesh-study-external-aerodynamics-problem/85030 "2019-04-11T02:02:10Z")\
**Posts on this page:** 1\
**Showing post:** 9

<div class="post-metadata">

**Author:** ![DaleKramer](https://www.simscale.com/forum/user_avatar/www.simscale.com/dalekramer/32/20201_2.png) [@DaleKramer](https://www.simscale.com/forum/u/DaleKramer)\
**Post date:** [April 11, 2019, 4:36pm UTC](https://www.simscale.com/forum/t/mesh-study-external-aerodynamics-problem/85030/9 "2019-04-11T16:36:24Z")

</div>

> [@anirudh2821998](#):
>
> The yplus value on the surface seems to be good

For me I would have to say the jury is still out on that Y+ mapping, is this for Full resolution Y+ values or Wall functions at 30\<Y+\<300

Looks like a lot of Y+ could be in bad territory between using either Full res or Wall functions…

I think that Bad area for us using κ-ω SST is 10\<Y+\<30 [according to this](https://www.simscale.com/forum/t/very-thin-boundary-layers-and-y-on-complex-geometry/84943/57) (but I just recently learned this and have not run any validity test on this range)

I hope you or someone else tries to make those Eddy Viscosity Ratio plots, saving me the time to figure them out 😉

---

_[View the full topic](https://www.simscale.com/forum/t/mesh-study-external-aerodynamics-problem/85030)._
