# FSAE - CFD Webinar - homework 2

**URL:** <https://www.simscale.com/forum/t/fsae-cfd-webinar-homework-2/56573>\
**Category:** Project Support\
**Created:** [December 11, 2016, 8:00pm UTC](https://www.simscale.com/forum/t/fsae-cfd-webinar-homework-2/56573 "2016-12-11T20:00:19Z")\
**Posts on this page:** 1\
**Showing post:** 4

<div class="post-metadata">

**Author:** ![anon18194957](https://www.simscale.com/forum/letter_avatar/anon18194957/32/6_449c533f586939b6e5f246632a46421f.png) [@anon18194957](https://www.simscale.com/forum/u/anon18194957)\
**Post date:** [December 12, 2016, 3:53pm UTC](https://www.simscale.com/forum/t/fsae-cfd-webinar-homework-2/56573/4 "2016-12-12T15:53:23Z")

</div>

Hi @dwagner.

You are correct in fact in the set up -I did not read deeply enough into the tutorial.

My colleague Ali has written an update that might be relevant to your case:

> [@Step-by-Step Tutorial: Homework of Session 2](https://www.simscale.com/forum/t/step-by-step-tutorial-homework-of-session-2/55690/87):
>
> Hello Everyone, @varunsura , @PhilippB94, @durgesh786 , @agupta , @fhnx ,@LoganZundel , @slibbi , @kianz89IMPORTANT NOTE: for all who are facing issue of strange simulation results e.g the figure below What was causing this ? The reason for this was a lot of illegal cells ( bad quality ) in the mesh. You can check that by clicking the meshing log as shown in the figure below: In most cases, the number was around approx 200 illegal cells which then requires more iterations…

---

_[View the full topic](https://www.simscale.com/forum/t/fsae-cfd-webinar-homework-2/56573)._
