'Flow thru duct - homework' simulation project by tlierfeld


#1

I created a new simulation project called 'Flow thru duct - homework':

VDI homework 1


More of my public projects can be found here.


#2

Model with 0deg set up following the manual, and did the meshing and simulation.

Imported geometry 2 (+10deg) and geometry 3 (-10deg).

Meshed geometry 2, but it seemed to be necessary to set all boundary conditions and refinements again. Not sure, if this is the right approach (would not be very convenient in a larger parametric study to perform all the clicking again and again...). Stopped here.