SimScale CAE Forum

Error while simulation Data center cooling

Hello,
I am having some errors while simulating the Data center cooling process.
I ran the simulation and after few minutes it showed me the message as given below:
“Velocity field started diverging. Please check the mesh quality near the reported location and try refining the mesh. If the problem occurred near a boundary, please check the boundary conditions.”
The specific location where it happened is at position: (-3.704 m, -5.412 m, 2.925 m) where the value of velocity is :1.21598e+07.

Can anyone help me out with solving the problem or give some suggestions as to what should be my mesh quality at the given specific location above?

I have pasted the link of the project below:
https://www.simscale.com/workbench/?pid=3675124234203830280&mi=spec%3A6e35ebc7-f602-48c1-8c1a-6ce851597a42%2Cservice%3ASIMULATION%2Cstrategy%3A37

Thank you.

Regards,
Suchit S Apage

Hi @sapage ,

Have you already gone through the steps described in this article?

Cheers

1 Like

Not yet.
But I will go through it.
Thanks!

Regards,

1 Like