# Drone Sensor Surface Sizing Help

**URL:** <https://www.simscale.com/forum/t/drone-sensor-surface-sizing-help/101458>\
**Category:** Project Support\
**Created:** [November 17, 2026, 1:35pm UTC](https://www.simscale.com/forum/t/drone-sensor-surface-sizing-help/101458 "2026-11-17T13:35:49Z")\
**Posts on this page:** 1\
**Page:** 1

<div class="post-metadata">

**Author:** ![dereklund9](https://www.simscale.com/forum/letter_avatar/dereklund9/32/6_449c533f586939b6e5f246632a46421f.png) [@dereklund9](https://www.simscale.com/forum/u/dereklund9)\
**Post date:** [November 17, 2026, 1:35pm UTC](https://www.simscale.com/forum/t/drone-sensor-surface-sizing-help/101458/1 "2026-11-17T13:35:49Z")

</div>

I can’t figure out why, but my surface custom sizing is scoping to some faces of my drone, but not others. It is supposed to scope to the entire surface, but I can’t get it to scope to important regions like the wings or fins.

[https://www.simscale.com/workbench/?pid=8843474035284363066&location=simulation:aaff3302-3cf1-42aa-ba30-94f4a92acd8a](https://www.simscale.com/workbench/?pid=8843474035284363066&location=simulation:aaff3302-3cf1-42aa-ba30-94f4a92acd8a)
