# Convergence Problems

**URL:** <https://www.simscale.com/forum/t/convergence-problems/87693>\
**Category:** Project Support\
**Created:** [February 13, 2020, 3:20pm UTC](https://www.simscale.com/forum/t/convergence-problems/87693 "2020-02-13T15:20:20Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![Ricardopg](https://www.simscale.com/forum/user_avatar/www.simscale.com/ricardopg/32/26909_2.png) [@Ricardopg](https://www.simscale.com/forum/u/Ricardopg)\
**Post date:** [February 13, 2020, 5:03pm UTC](https://www.simscale.com/forum/t/convergence-problems/87693/2 "2020-02-13T17:03:34Z")

</div>

Hey @mde_mendon_a_d,

These residual plots are indeed not looking very good. But the wing’s angle of attack is quite high aswell, 45 degrees.

In your first simulation, the mesh is a bit weird. Apparently you assigned a region refinement covering only 2/3 of the wingspan.

 ![image](https://www.simscale.com/forum/uploads/default/original/3X/c/8/c88ea3dc39bb8985a764b003654a1268e38cace5.png)

Take a look at the following sessions of the aerospace workshop: [optimization of a wing - meshing](https://www.simscale.com/forum/t/workshop-2-session-1-homework-optimization-of-a-wing-part-i-meshing/42436) and [optimization of a wing - set up](https://www.simscale.com/forum/t/workshop-2-session-1-homework-optimization-of-a-wing-part-ii/42726). You’ll find the general workflow here. In case of any doubts, please make another post 😛

---

_[View the full topic](https://www.simscale.com/forum/t/convergence-problems/87693)._
